Clevr Energy Display

Your solar system, live on a wall-mounted touchscreen.

A dedicated 4 or 5 inch display that shows where your power comes from and where it goes: solar production, battery charge, grid import and export, and what your home is using right now.

Check your equipment Buy a display

Solar

Battery

Grid

Home

With Home Assistant

More than live values

Connected to Home Assistant, the display adds four screens: live flow with per-phase detail, today's totals, hourly and weekly history, and a solar forecast. Shown here on the 5 inch panel with a Victron GX system.

Two ways to run it

The same display works on its own or alongside Home Assistant. You can start standalone and switch later without new hardware.

Standalone Display talks directly to your equipment

The display joins your home Wi-Fi and reads values straight from your inverter or Victron GX device using Modbus TCP, the standard way inverters share readings over a local network. Nothing else needs to run in your home.

You get Live power flowBattery charge and statusToday's totalsInverter alarms

You need 2.4 GHz Wi-FiInverter on the same networkModbus TCP enabled

Best for: a simple, single-purpose display with minimal setup.

With Home Assistant Display reads from your smart-home hub

Home Assistant is free, open-source software that collects data from devices around your home. Connected to it, the display can combine several sources and show history and forecasts alongside live values.

Adds Energy historySolar forecastMultiple inverters combinedAny brand Home Assistant reads

You need A running Home AssistantThe ESPHome integrationYour energy sensors in Home Assistant

Best for: households that already use Home Assistant or want more than live values.

Is my equipment supported?

Pick your manufacturer to see how the display connects and where the installation guide lives.

Connects through {{ sel.name }} {{ sel.via }}

Operating modes

Standalone{{ sel.saNote }}

Home Assistant{{ sel.haNote }}

Installation guide {{ sel.host }} {{ sel.status }}

Brand not listed? If Home Assistant can read your system, the display can show it in Home Assistant mode.

Choose your panel

Both panels are Guition touchscreens built around an ESP32-S3, a small Wi-Fi-capable processor. They ship with the Clevr Energy Display firmware installed.

From box to live dashboard

Each manufacturer has its own guide on a dedicated site, written for that equipment's menus and settings.

{{ g.name }} guide {{ g.host }} {{ g.covers }}